PDA

View Full Version : OHnar slide copier model W-1337. Not sharp!



themannsindorset
13-10-13, 06:46 PM
I have just purchased this copier so that I could digitise hundreds of slides. The copier is attached to my Konica Minolta Dynax 5d using a minolta 7000 T mount. The results are not sharp. I have double checked everything but to no avail. I have two questions?
1. Is the minolta 7000 T mount the correct one? I ask this in case the mount is pushing out or pulling in the copier throwing copier out of focus. Is there or was there a Konica/minolta T mount?
2. I used a tungsten light source very close to the copier. Could this be a problem? I am wondering if a point light source further way by improve things? Grabbing at straws here.
I doubt that the copier is faulty as its a simple thing but I will cross that bridge if I have to.
Peter